Фольксваген Golf Носоk not dead › Logbook › Replacement of a cable of coupling
When it comes to the car, surprise is the first thing to expect. So I have. I got ready for the interview, warmed up, drove, got into the traffic jam. I roll on the sly, jump to a lower one and bam! The pedal remained in the floor. On examination, I saw that the bracket was flying off the cable that held it down.
In such cases (the benefit is not far away), the car is muffled, we turn on the first gear, start at our speed and go on it to the house, or to the service.
First of all, I ordered the bracket (1H0 798 303 A) original for 200 rubles.
Well, I decided to order a cable (1H1 721 335 A) for 2600 rubles. while the money is)))
INSTALLATION: It takes 15-20 minutes (I took 2 hours of inexperience, but now I know how to do it here)
When the cable is already taken off, we jack the clutch lever as much as possible (I repeat, as much as the car will rise, but this reptile will still rise)
Golf 2. Народный автомобиль! Как натянуть тросик сцепления в этом видео вы увидите как мы без лишнего труда.
не всегда для ремонта сцепы надо снимать коробку. хитрый ремонт.
Remove the lid where the fuses are and unscrew the plastic on the 4 self-tapping screws under the steering wheel, this is more than enough, the pedals and stuff need not be removed. I faked the cable so that he got out of the seat and pulled out from the side of the engine.
Next, insert the cable into the interior by pre-stretching more in the vicinity of the vacuum amplifier …
Here it is important that the second pair of hands found it and put it in the landing area strictly horizontally, I took the advice of the experienced and made myself such a hook …
Then we insert the cable into the mounting seat of the bracket and fasten it with a metal lock (I constantly lacked space until I hoisted the maximum lever so that there could be two locks), and we lowered the lever from the jack.
After the pedal was tight pressed, for this, in short quick movements we drive the pedal of the link (pump), click the fasteners in the pedals, thus it is clear that everything has fallen into place. And now the pedal began to walk as it should)
I collect everything and voila! Done. As a result, there was a smooth switching, very pleased, well, peace of mind. And the cable is new and fasten. Well, I learned something)))
All the world! Who likes to put the likes!